WLC Access via RADIUS Cisco ISE 2.2.0 Patch1

[albertofdez]

Hi guys,

This had worked for me smoothly in previous versions of Cisco ISE and WLC using this Results

"Service-Type" Radius Attribute setting to "Administrative"

But now with Cisco ISE 2.2.0 Patch1 and WLC 8.2.151.0 I access the management without problems but when I try to make any changes or save the configuration gives me this message

Authorization failed. Not sufficient privileges.

This message is normal for a read-only user and configured the attribute as "NAS-prompt".

Do you know that he could change in these versions?

Best regards.

[jrabinow]

Please install 2.2 patch 2 and will address this issue. The patch is available on CCO

Relevant CDETS is CSCvd61189: ISE2.2 incorrect RADIUS service-type attribute sent