01-14-2021 03:11 AM
Hi All,
I cannot config the service-policy for the port-channel subinterface using RESTconf in CSR1000V.
Also, There was no service-policy information in the GET even if it was configured in the CLI.
I am trying CSR1000V, IOS-XE16.12.3.
=====================
〇CLI Config
interface Port-channel1.1000
encapsulation dot1Q 1000
ip address 100.100.100.1 255.255.255.252
service-policy output TEST_policy ★target config
〇Result of GET
{
"Cisco-IOS-XE-native:Port-channel-subinterface": {
"Port-channel": [
{
"name": "1.1000",
"encapsulation": {
"dot1Q": {
"vlan-id": 1000
}
},
"ip": {
"address": {
"primary": {
"address": "100.100.100.1",
"mask": "255.255.255.252"
}
}
}
}
]
}
}
=====================
If service-policy is config to GigabitEthernet subinterface or port-channel, the problem does not occur.
I would like to configure the settings for ASR1001-HX as well. Will the same problem occur for ASR?
Is there any solution to this problem?
Solved! Go to Solution.
02-11-2021 08:38 PM
Hello alexstev
Thank you for your reply.
When I contacted CIsco TAC, I found that it was not supported.
We have received the answer that this will be implemented in future OS as an enhancement.
02-11-2021 10:10 AM
Hello @m-hosaka,
Welcome! I'm not an expert with this particular technology, although I have worked with this class of router and software previously. Here are my insights:
These might not give you the answer you're looking for but at least may give you some ideas and point you in the right direction. I hope this helps.
02-11-2021 08:38 PM
Hello alexstev
Thank you for your reply.
When I contacted CIsco TAC, I found that it was not supported.
We have received the answer that this will be implemented in future OS as an enhancement.
02-12-2021 06:19 AM
Thank you for giving us the solution @m-hosaka !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide