11-22-2021 07:04 AM
I know zero about 5505 ASA's and my director tasked me with configuring and sending to off site location to add to the existing 2 cisco 2960S's. Can someone help me on how to config this 5505 so that it can be wired into those?
11-22-2021 07:21 AM - edited 11-22-2021 07:22 AM
Good Morning barryrosenhouse,
I apologize I cannot answer your question, but reading the threads over the past couple years I do know that there's going to be more information needed for your question. Here are a few that I thought of?
How is it going to be configured? As an edge router? Or will it be behind your edge routers as far as an internal firewall of sorts?
Is there a DMVPN, or any type of VPN service that needs to be considered?
VOIP?
11-22-2021 08:04 AM
Michael,
not as an edge router, just firewall behind AT&T's edge router, there might be 1 voip phone attached.
11-22-2021 07:27 AM
- That is going to be difficult without some minimum knowledge of cisco's networking and equipment, I found a few resources : https://www.youtube.com/watch?v=F6qvKRFn-xc and https://www.youtube.com/watch?v=DmBa0W0-ANE
M.
11-22-2021 08:04 AM
Thanks Marce1000
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide