Adding devices to existing community Network Assistant

[Jkisler99]

Just starting to use Cisco's Network Assistant but i cant figure out how to add more switches to an existing community.

Whats the best way to add more devices to a already existing Community?

Version: 6.3

Thanks in advanced!

[Marvin Rhoads · Accepted solution]

There are two ways, depending on whether it's on your topology view already as a neighbor. If it's not then:

1. Application > Communities > select the Community you wish to add switch to and then > Modify. In the resultant window discover it/them by IP address or range.

...otherwise then:

2. If it's already a neighbor of an existing community member, right click it in the Topology view and select "Add to Community".