cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Alarm Generation in cisco IOS XR - Logically

akshaypb6
Beginner
Beginner

Hi Team,

 

There is requirement to check whether the new Alarm monitoring System in the network is able to capture all the new alarms generated in the nodes.

 

For that we need to generate the alarms in the lab test node integrated with the alarm monitoring system and check whether the alarms are getting captured.

 

Kindly let me know if in case any of the following alarms can be made by the config changes in the nodes please.

 

1.isisDatabaseOverloaded

2.isisOwnLSPPurge

3.isisProtocolsSupportedMismatch

4.isisSequenceNumberSkip

5.Optical Alarm

6.PKT_INFRA-LINK-3-DOWN

7.RP-RED-LOST-NSRNR

8.SWT_AUTH_FAIL

9.cefcPowerStatusChange

10.ConfigArchive

 

Thanks in advance 

1 REPLY 1

Kasun Bandara
VIP Advocate VIP Advocate
VIP Advocate

Hi,

 

use below link to get guide for this. 
https://community.cisco.com/t5/xr-os-and-platforms/isis-adjacency-monitoring-under-ios-xr-4-3-1/td-p/2331557

 

you can use relevant SNMP OIDs to trap and monitor.

 

Good luck

KB

mark this solved or up vote if you got solved your concern

Please rate this and mark as solution/answer, if this resolved your issue
Good luck
KB
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: