cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1330
Views
0
Helpful
3
Replies

Alerts on interfaces I want to exclude - LMS 4.1

edgertonj
Level 1
Level 1

I have an inventory added to Ciscoworks and am getting alerts on interfaces that I want to exclude but for the life of me I can't figure out how to exclude interfaces. Any tips on how to exclude interfaces from the fault engine in 4.1 would be greatly appreciated!

--

Jason Edgerton

1 Accepted Solution

Accepted Solutions

Marvin Rhoads
Hall of Fame
Hall of Fame

You need to change the polled interfaces per the following documentation instructions:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.1/user/guide/monitoring_troubleshooting/mnt-fault.html#wp1586643

You can exclude any or all physical interfaces and/or IP addresses (excluding the address used to poll the system).

Hope this helps.

View solution in original post

3 Replies 3

Marvin Rhoads
Hall of Fame
Hall of Fame

You need to change the polled interfaces per the following documentation instructions:

http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.1/user/guide/monitoring_troubleshooting/mnt-fault.html#wp1586643

You can exclude any or all physical interfaces and/or IP addresses (excluding the address used to poll the system).

Hope this helps.

Thanks a bunch! A simple thing to be sure, but for some reason I was struggling trying to find it.

_

Jason

Jason,

You're welcome. Glad to be of assistance and thanks for the rating!