ASA and SNMPv3

[patrias]

Hi,

LMS 3.2.1 and ASA 5510 configured for SNMPv3 access,

Inventory and Config sync works, so i think SNMPv3 must work,

but a credential check says SNMPv3 is not supported,

Device Packages are updated,

best regards

Alex

[Joe Clarke]

You're currently seeing the results of CSCtd67173.  SNMPv3 support on the ASA is limited in that read-write support is not available.  Therefore, LMS will report "Not supported."  This is expected.  All SNMPv3 read-only collection operations will work in LMS 3.2.1, however.

[patrias]

thanks