Is it possible to have 2 bridge groups on one serial interface?
no ip routing
!
interface FastEthernet 0/0
ip address 10.1.1.88 255.255.255.0
no ip route-cache
speed 10
half-duplex
priority-group 1
bridge-group 1
# bridge-group 1 input-pattern-list 1100
no shutdown
!
!
interface FastEthernet 0/1
ip address 10.1.2.89 255.255.255.0
no ip route-cache
speed 10
half-duplex
priority-group 1
bridge-group 2
# bridge-group 1 input-pattern-list 1100
no shutdown
!
interface Serial 0/0/0
no ip address
no ip route-cache
priority-group 1
service-module t1 clock source line
service-module t1 data-coding normal
service-module t1 timeslots 1-4 speed 64
service-module t1 linecode b8zs
service-module t1 fdl ansi
bridge-group 1
bridge-group 1 circuit-group 1
bridge-group 2
bridge-group 2 circuit-group 2
no shutdown
!
no ip classless
!
# Clear out access lists
#no access-list 1100
!
ip forward-protocol spanning-tree
ip forward-protocol udp 3201
ip forward-protocol udp 3202
ip forward-protocol udp 3203
!
!
priority-list 1 protocol ip high udp 3201
priority-list 1 protocol ip medium udp 3202
priority-list 1 protocol ip normal udp 3203
priority-list 1 default low
bridge 1 protocol ieee
bridge 2 protocol ieee
!
line con 0
exec-timeout 0 0
line vty 0 4
