Can IOS do an nslookup?

[sdaniels44]

I have a switch configured to resolve hostnames, it works fine, if I ping xxx.xxx.local or whatever it looks up the IP and displays output.

Can this be done in reverse? So If I find an IP address in the arp table and want to resolve its hostname, is there a command like Windows nslookup that will allow for this?

[Joe Clarke · Accepted solution]

There is nothing built-in, but attached is a Tcl script I wrote to do A and PTR DNS lookups using the IOS tclsh (in IOS 12.3(2)T or later, 12.2(18)SXF5 or higher, 12.2(40)SE or higher, etc.). Tclsh doesn't support UDP sockets right now, so my script uses TCP. It works similarly to the UNIX host command. If you do not specify a DNS server, it tries to obtain one by looking at the device's config. The usage is:

host.tcl address [dns_server]

For example:

Router#tclsh flash:host.tcl 10.1.1.1

1.1.1.10.in-addr.arpa domain name pointer host.company.com

Router#tclsh flash:host.tcl host.company.com

host.company.com has address 10.1.1.1

The script is pretty simplistic, but it should accomplish what you want.

[sdaniels44]

Thats pretty cool. Thanks!

[Nish Vamadevan]

Thanks Joseph,

Added the alias to makes things easier and lazier...

#alias exec host tclsh flash:host.tcl

[Joe Clarke]

I've posted an updated version of my host.tcl with UDP and IPv6 support at http://forums.cisco.com/eforum/servlet/EEM;jsessionid=3BBA522C4C95130B9EE7E8EF010F6BB8.SJ1A?page=eem&fn=script&scriptId=2507 .

[synack000]

Joe,

The above link you posted is not working. Is the updated script still available?

Thanks.

[Joe Clarke]

Script is available at https://supportforums.cisco.com/docs/DOC-19590 .

[Denis_from_BE]

The script is not available anymore. Can you please re-upload it ?

[Ludovic Kuty]

I think it is available at https://community.cisco.com/t5/networking-documents/tclsh-implementation-of-host-nm/ta-p/3123994

It is in the archive named

116526-Tclsh_implementation_of_host(1)

I did not test it yet.

[smeroz]

Although this post is quite old, it is yet very helpful.

Is there a way to make the script's lookup process to run through a specific interface?

[jasonmadruga84]

On my 2940 switch I can issue the traceroute command on an ip address and it will do a reverse DNS lookup. Be sure to keep the CTRL+Shift+6 command handy as traceroute can go for a while sometimes.