Cat3750 temperature

[pppyyyppp]

We are running 3750 ((C3750-IPBASE-M), Version 12.2(25)SEB4).

show env temperature

TEMPERATURE is OK

Is there an OID that we can get to snmp monitor the switch temperature?

[proy]

try:

1.3.6.1.4.1.9.5.1.2.13

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?objectInput=chassisTempAlarm+&translate=Translate&submitValue=SUBMIT

Regards,

Phil.

[rajinikanth]

Hi,

Check this link with MIBS for temperature check.

http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&mibName=OLD-CISCO-CHASSIS-MIB

Hope it helps u

Raj

[andrew.burns]

Hi,

Temperature values are only supported on the following switches:

3750G-48TS, 3750G-48PS, 3750G-24TS, and 3750G-24PS

HTH

Andrew.

[pppyyyppp]

Hi Andrew,

Our switch is WS-C3750G-24TS-S. When do show env temp, it shows only "TEMPERATURE is OK".

Do you have the OID for the temperature values?

Thanks

[pppyyyppp]

show env temperature status

Temperature Value: Not Supported

Temperature State: Not Supported

It's look like the temperature value is not supported.

Andrew, can confirmed this.

[sbhadrav@cisco.com]

A quick note on the output of the Catalyst 3750. show env power only shows the status of the built-in power supply. If you are using an RPS on this system, you need to use show env all to get the RPS status as well

[kingdwight1]

This is not the OID you are looking for but if you run show env temperature status

you should get something like this...

MY-SWITCH1# show env temperature status
System Temperature Value: 31 Degree Celsius
System Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold : 60 Degree Celsius

Hope that helps future readers.