09-03-2006 07:36 PM
We are running 3750 ((C3750-IPBASE-M), Version 12.2(25)SEB4).
show env temperature
TEMPERATURE is OK
Is there an OID that we can get to snmp monitor the switch temperature?
09-03-2006 10:43 PM
try:
1.3.6.1.4.1.9.5.1.2.13
Regards,
Phil.
09-04-2006 12:02 AM
Hi,
Check this link with MIBS for temperature check.
http://tools.cisco.com/Support/SNMP/do/BrowseMIB.do?local=en&mibName=OLD-CISCO-CHASSIS-MIB
Hope it helps u
Raj
09-04-2006 07:08 AM
Hi,
Temperature values are only supported on the following switches:
3750G-48TS, 3750G-48PS, 3750G-24TS, and 3750G-24PS
HTH
Andrew.
09-04-2006 08:56 AM
Hi Andrew,
Our switch is WS-C3750G-24TS-S. When do show env temp, it shows only "TEMPERATURE is OK".
Do you have the OID for the temperature values?
Thanks
09-04-2006 09:00 AM
show env temperature status
Temperature Value: Not Supported
Temperature State: Not Supported
It's look like the temperature value is not supported.
Andrew, can confirmed this.
02-28-2018 10:35 PM
A quick note on the output of the Catalyst 3750. show env power only shows the status of the built-in power supply. If you are using an RPS on this system, you need to use show env all to get the RPS status as well
01-18-2022 04:57 PM
This is not the OID you are looking for but if you run show env temperature status
you should get something like this...
MY-SWITCH1# show env temperature status
System Temperature Value: 31 Degree Celsius
System Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold : 60 Degree Celsius
Hope that helps future readers.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide