CDP enabled on access ports (On a trunking port)

david.hudson · ‎04-23-2010

I have LMS 3.1 installed on a Windows box and get the following best practice deviation listed in CM:

CDP enabled on access ports

The problem is, these ports are configured as trunks. They are not set to switchport mode access. Any ideas?

Joe Clarke · ‎04-23-2010

What version of Campus Manager do you have? It could be that Data Collection is not properly completing, and thus not detecting that these are trunk ports.

david.hudson · ‎04-24-2010

CM version is 5.1.0.

Looking at the configs in RME, I can see that the entire config is pulled correctly.

Joe Clarke · ‎04-25-2010

RME has nothing to do with the Campus topology. I think you're seeing a known bug. Upgrade to Campus Manager 5.1.4 from Common Services > Software Center > Software Update. Then run a new Data Collection, and this BPD should disappear.

Sean Gilkes · ‎11-25-2010

Hi Joseph,

We are running Campus Manager 5.2.1 and we're seeing exactly the same issue. Is there anything I could try doing before opening a TAC case..? Also you mentioned that this was a reported bug in version 5.1, but I could not find any bug listing in the Bug Toolkit; would you know the bug ID..?

Cheers,

SRGi

Joe Clarke · ‎11-25-2010

Please start a new thread for your issue, and post the ani.log when you do.