Network Management

Hello friends,We have 50 Mbps for Internet access, and lately we have been experimenting congestion on the link, everyday from 10AM up to 12PM. We use cisco router 3825 for Internet access. After running NBAR we found a lot of peer-to-peer/file shari...

If i setup syslog severity 5 in the syslog message filter, does this mean i will get syslog from 1 - 5 on LMS?Thanks,Aamir    

Hello!I haven't worked with Ciscoworks in a long time and see v4.0 is out. Does anyone if this app is a good tool to monitor bandwidth utilization? We need a good product that can monitor utilization on our WAN circuits and also doing regular backups...

I want to change the ip address on multiple devices configration.( the ip address will be different on each devices) is that possible to do on RME net config? i know I can do one command and valu on multiple devices but not sure if this possible. Tha...

Hello,I want to configure CiscoWorks Assistance  I got error message "Error in communicating with DCR Server.DCR Server may be down. Please start the DCR Server and then refresh the page. ". I picked up CS-server-admin-Process, I found process "DCRSe...

Hi All, I have done the syslog remote configuration on the switch. However, logs are not being received to the server and when doing capture on the firewall, we have noticed that the switch is not sending the logs to the default port UDP 514 but to r...

Dear *,Is there a way to only uninstall invidivual components in LMS 3.2 on solaris 10, like just uninstall DFM or IPM etc?Thanks,Aamir

I have added 130 devices in DCR through CSV file,Alls are showing in CS moduls but those are not come in DFM module.I am put all modules in auto allocation modeI have restarted services (crmdmgtd)  and also restarted hard reboot server.I have also ch...

Dear *,I have a weird problem about syslog time. I get correct syslog timestamp on the router and syslog_info but when i go on RME to see report i get incorrect time. Infact time is future, plz check time stamp on below of the same message in syslog_...

I want to add devices to DCR from CS,but when I chose CS-Device and Credentials, I got error message "Error in communicating with DCR Server.DCR Server may be down. Please start the DCR Server and then refresh the page. ". I picked up CS-server-admin...

I have built a simple eem applet to monitor snmp oids in the SIP user agent and take action using cli commands to re-register with a new SIP proxy.  But the applet is too sensitive and creates more problems than it solves.  To improve on it, I want t...

I'm looking for a way to report what device an unreachable device was discovered through.  Example, I have an unreachable device that I want to configure, but I need to know what device that is reachable that the unreachable device is connected to.  ...