10-18-2005 03:18 AM
As we have to change from CAT-OS to IOS on our switches I´m searching for a way to alter duplex-mode and Port-Speed on Catalyst 4000/6500-Switches via SNMP. I have OIDs for read-only-access but i did not succeed in setting the values. Do you know the right way/OID?
Thanks a lot for your help!
Ralf
10-24-2005 06:08 AM
Try this command
snmpwalk -c public
MAU-MIB::ifMauDefaultType.5.1 = OID: SNMPv2-SMI::zeroDotZero
Set the ifMauDefaultType so it is not zeroDotZero then you should be able to set the ifMauAutoNegAdminStatus. Hope this helps.
12-20-2005 04:30 AM
Dear R-Warnecke,
I'm very interested in even "reading" the duplex-mode of my switch-ports. I tried
snmpwalk berl-sw01-1 xxxxxxx .1.3.6.1.2.1.26, but i get no reply, probably the switch doesn't support the "mau-mib"? snmpwalk with other oids works fine.
We use IOS-Switches catalyst 6000, 2950 with ios V.12.1...
Do You have an idea how to read the duplex-mode-settings?
best regards
Frank
OSRAM, Berlin
12-28-2005 10:21 AM
Use the following oids to set port speed and duplex settings.
CISCO-STACK-MIB::portAdminSpeed
CISCO-STACK-MIB::portDuplex
--
Prakash.
12-28-2005 10:23 AM
Use the following oids to set port speed and duplex settings.
CISCO-STACK-MIB::portAdminSpeed
CISCO-STACK-MIB::portDuplex
--
Prakash.
01-02-2006 02:46 AM
Hello Prakash,
I wish you a happy new year.
Thanks for your advice, but unfortunately it seems that most of my switches doesn't support this mib.
Frank.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide