04-26-2024 05:52 AM
I'm new to this so please be kind
Setting up a Cisco 1010 Firepower device, unboxed it, got it up and running, havent' did any config yet, so its all the defaults I would say. Needed to bring it to the office, once I turn it on, no port lights come on, and I've left it on for a day.
I have all 3 green lights on the top, with the middle one flashing.
need some help please
04-26-2024 05:53 AM
check the duplex and Speed in Device connect to FPR
MHM
04-26-2024 06:12 AM
wow thanks for the quick reply ! How would I check that? I can only get to the console with Rommon 1 prompt?
04-26-2024 07:58 AM - edited 04-26-2024 09:57 AM
MHM
04-26-2024 06:32 AM
If the device gets stuck into rommon mode you might need to re-image it. Check out this guide please:
04-26-2024 07:29 AM
Thanks @Aref Alsouqi I've re-imaged it, doing the same thing. no lights on the 8 ports. If I go to putty and type boot, it will boot and lights come on, then I do a reboot, lights off. I'm missing something somewhere
04-26-2024 07:55 AM
You're welcome. It could be related to a wrong config-register value. From rommon try please to type the "confreg 0x1" and see if that fixes the issue.
04-26-2024 07:56 AM
If that command does not work, please try to issue the command "confreg" and hit enter, and hopefully that will fix it.
04-26-2024 09:55 AM
thank you !!! that did it, back online now
04-30-2024 02:02 AM
You're welcome. Out of interest, which one of the suggested solutions work? the "confreg 0x1" or "confreg" followed by hitting enter? please mark the correct answer to benefit the other readers.
04-30-2024 06:36 AM
confreg 0x1 worked for me
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide