Solved: Re: cisco 2960-x express setup does not submit ip settings

BG147 · ‎05-04-2021

After applying new ip settings in express setup, I press submit but the changes do not apply.

A new page opens to the new ip but after setting nic to the same subnet I cannot connect.

I change back to dhcp and connect to the default 10.0.0.1 again.

i have tried multiple browsers and computers.

marce1000 · ‎05-04-2021

- Is there an error when you press Submit ? You may be able to initially configure through the console, check this thread :

https://community.spiceworks.com/topic/1243946-cisco-2960g-24tc-l-no-express-setup-after-resetting

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

View solution in original post

marce1000 · ‎05-04-2021

- Is there an error when you press Submit ? You may be able to initially configure through the console, check this thread :

https://community.spiceworks.com/topic/1243946-cisco-2960g-24tc-l-no-express-setup-after-resetting

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

BG147 · ‎05-04-2021

Hello, No no error...

marce1000 · ‎05-04-2021

- Ok , as stated check out the thread.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

BG147 · ‎05-04-2021

Thank you! ive been at it for a few hours! This worked

BG147 · ‎05-04-2021

Do you know how to reset the switch from CLI? Pressing the mode button does not do a factory reset as manual states. I cannot log into one switch because the default password doesn’t work.