cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
236
Views
0
Helpful
1
Replies

Cisco 870 Config

cgarlick1972
Level 1
Level 1

(Config added as txt because post kept getting mark SPAM with no reason given)

Below is my full config (With passwords/IPs removed)

I have my router with a Public IP connected directly to the internet MAC bridged

(Home internet WIFI on the modem on 192.168.0.0)

My Public server is 10.0.40.252 On my DMZ2 (Nat porting only what I want to access the server)

My private network is on 10.0.10.0 255.255.255.0 (192.168.0.0 WIFI on the modem)

(Ethernet 1&2 and Vlan2&Vlan3 not in use)

#1 I need to set it up so I add a ip nat inside source static tcp 10.0.40.252 PORT interface FastEthernet4 PORT with no acces to the other networks

#2 I would like to access 10.0.40.252 from my other networks (10.0.10.0 and 192.168.0.0)

I had this set up working perfectly and my ISP changed my modem and I cant seen to get it right again. (Back up did not work)

Any security issue or improvments to my setup appreciated!

 

1 Reply 1

@cgarlick1972 

 How can you be sure that on this modem change, something was not change on the ISP side? The config on the router seems to be ok.

Review Cisco Networking for a $25 gift card