cisco catalyst express 500 with PoE configure via web interface defaul

[christiaanh2]

Hi everyone I have a problem I want to configure my Cisco Catalyst Express 500 but I can't get into the web interface to configure the Switch does anyone know how to get into the web interface to configure the Switch I have four ip Phones

that I would like to use on this Switch because it has PoE

[marce1000]

 - FYI : https://community.cisco.com/t5/networking-documents/how-to-configure-a-cisco-catalyst-express-500-series-switch/ta-p/3126702

 M.

[christiaanh2]

does that IP address also apply to Belgium

[balaji.bandi]

Reset to factory default and test it, if this was not new.

the default IP same all over ( not related to region)

[christiaanh2]

I've followed the instructions but I still can't get into the Switch Interface could it be because I'm using Windows 11

[balaji.bandi]

are you able to ping the IP address of the switch ? follow the below guide?

https://community.cisco.com/kxiwq67737/attachments/kxiwq67737/6016-discussions-lan-switching-routing/60454/1/10034-500.pdf