Hey folks,
I want to configure telemetry in my Cisco Nexus 93xxx switch infrastructure. DCNM is on version 11.1.1, installed in LAN mode (no fabric). My nexus switches are on 7.0(3)I6(1).
If I enable telemetry, it fails. Looking in the job status, the configuration stucks at the following line:
sensor-group 501
path sys/bd depth unbounded query-condition query-target=subtree&target-subtree-class=l2BD
path sys/intf depth unbounded query-condition query-target=subtree&target-subtree-class=rmonEtherStats,[...]
Problem is, the syntax is invalid. If I enter the cmd in the switch, there is no "query-condition", only "filter-condition".
Does anyone use telemetry successfully or know this problem?
best regards
/Hugo