Cisco LMS 4: Monitoring router with multiple ospf processes

[alex.dersch]

Hello,

i'd like to monitor the OSPF process of my MPLS routers by SNMP. I created templates for

ospfIfEvents

ospfNbrEvents

ospfSpfRuns

ospfNbrState

ospfAreaLsaCount

but when i configure the poller i believe the data i mixed up somehow. I for example i don't get all neighbor in the ospfNbrState.

i tried with snmp context configuration but i am not sure if this right what i did.

any suggestions?

regards

Alex

[alex.dersch]

I could solve the monitoring issue with snmp context configuration. I had to map each OSPF process to a snmp community. So i could retrieve data for each OPSF process. My issue now is how to add multiple communities to an LMS controlled device.

As far as i know, LMS support only one RO community per device.

regards

alex