Hello,
I have an issue that i just cannot get past and I am looking for some input as to why this is not working.
First of all some info on what I am using:
Cisco Network Assistant Ver 5.6 (3)
Cisco SG-500 (set to layer 2)
HTTP: OFF
HTTPS: ON
Telnet: OFF
SSH: ON
SNMP: ON
When I try and do the initial add of the switch I am using the following settings:
Name:Name of the switch (advanced I left at default read/write, but have tried read only as well).
Company name: our name as a company
Discover: Have selected multiple options, but the FAQ seems to point towards "devices using a seed IP address"
Seed IP: Ip of the switch
When i select start i get a connection error, I am not going across subnets, nor is there a firewall or any type of blocking software in the way, I can ping and manage the switch via HTTPS without issue...
Am i missing something here?
Thank you in advance.
Don