Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1448
Views
0
Helpful
1
Replies

Cisco Network Assistant

mark_Bayliss
Level 1
Level 1

‎10-26-2005 07:46 PM

Hey Everyone,

I created a cluster on our Catalyst 3550 switch. We have around 30 2950-24T switches across our network. Unfortunately I can only have upto 16 switches in a cluster. Does anyone know the best way to over come this so I can have all my 30 switches under the one cluster?

Cheers,

Mark

Labels:
0 Helpful
1 Reply 1

wong34539
Level 6
Level 6

‎11-03-2005 07:04 AM

Make sure that all of the switches are connected using those ports in the same management VLAN. Access to all the cluster management facilities is through the command switch IP address. The command switch IP address always belongs to the management VLAN, which is VLAN1 by default.

All switches within the switch cluster must have the same management VLAN as the command switch.

0 Helpful
Customers Also Viewed These Support Documents