Cisco Prime 2.1 sh commands

[RICARDO SANCHEZ]

Hello

It is possible to take some show commands of a group in CiscoPrime 2.1 and then get this files?

Thanks for your help

Regards

[Marvin Rhoads]

I don't think so. This is a feature that was available in Prime LMS that has not yet been ported into PI.

[RICARDO SANCHEZ]

Thanks Marvin for your response.

And what about to make some changes in configuration  of a group, for example

• conf t
• no snmp-server community X
• snmp-server community C

It is possible to do whatever templet I want for a group in prime infraestructure 2.1?

Thanks for your help

Regards

[Marvin Rhoads · Accepted solution]

Sure.

In Lifecycle mode you design a template (Design, Feature Design, CLI Templates). See the existing pre-configured templates for examples. Then create one with the commands you want and give it a useful name. (You can adapt the "Configure SNMP" template for example.)

The deploy it: Deploy, Configuration Tasks:  

 Templates > CLI Templates > System Templates - CLI > Configure SNMP

Choose your device group, site group etc. as targets and then deploy.

[RICARDO SANCHEZ]

Thanks Marvin

I did that and Its works

regards