01-28-2016 02:52 AM
Hi,
Hopefully someone can help me understanding how this tool works, as it's completely undocumented by Cisco.
Here's the scenario.
You go go "Inventory->Device Management->Network Devices-> Wireless Controller.
Then you sort them on "Audit status mismatch".
Select any controller device and click "configure->audit now".
After the audit is done, you get these options that are really undocumented what they do:
Now the problem is that in this case, since the system has been down for a couple of days, engineers have been doing changes on the WLC's themselves not on any templates or from Prime. So the logic is to NOT push down values from prime to the controllers.
What I want to achieve is the reverse, to pull the configurations from the Controllers and have Prime audit them as "the valid working configuration".
So this is the information you get when you click "refresh config from controller" and it's extremely unclear what this warning message means:
Configuration Change | ||
|
What exactly does that mean?
Does it update the templates or just downloads the configuration from the WLC?
For now, no engineers are allowed to use prime until this has been sorted out. Since in 2.2 it used to update the templates and told prime to actually use the configuration pulled from the WLC's themselves. I am not sure about this message at all!
Thanks in advance.
03-21-2016 06:03 AM
Guess nobody knows?
I am horrified over the CPI documentation and the operation headaches it causes :(.
01-24-2022 07:46 AM
Did you ever find out the answer to this? I'm wondering the same...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide