I'm planning migration from SNMPv2 to SNMPv3 and wondering what's (is there?) a best practice as far as user/group design. It's very simple to create and use a RO and RW user and group. Other options include creating a set of groups and have the us...
I would like to deploy the IdenTrust Root CA onto our devices via a TCL script. Problem is, that the built-in ios_config syntax has some limitations. It will crash if you run it with alot of options. So i am looking into importing the cert in other w...
Hi community! I have a Cisco Smart Software Satellite(Versio 6.3.0)It seems to me that the Synchronisation ist not working anymore/hanged upThe Synchornisation is still running since 4 days and does not finishIn the Firepower Management Center the Li...
hi all,trying zabbix out and i want to make a template for my cisco switch so it picks up all the OIDs automatically and any other switches for that matterive enabled SNMPv2 on the switch, added it to zabbix via ip, its picked it upbut i want it to a...
Hello, sorry I can't figure this out....I have a Cisco router 2911 model running in production. It looks after Data and Voice for a site. Now, I want to have seconds router in the equation so I can separate them for Voice and Data. I have NEW running...
hello all, i would like to ask you for advice. i would need to send from my devices each hour a syslog message (for example heartbeat_nameofdevice) each hour to Qradar. those devices are nexus 9K (9.3.9) and ASA firewall. i tried to configure it with...
I have 2 4500 switches connected in VSS and I have on both a 10g SFP module with two servers connected to them in a 2 port port-channel , with each port connected to a switch. I'm suffering from low data transfer speed between one server that takes b...
Hi All, i am getting the following error when connecting a trunk link back to core switch:Topology:Core > SW1 > SW4 > CoreCore: VTP ServerEdge Switches : ClientVTP Version 1Domain has been setVTP password has been set all interfaces have the same con...
Hi, I'm new to SNMP and trying to change the bandwidth for specific port on switch.I could change the bandwidth for specific port with CLI.Now I'm trying to do the same using SNMP. However, OIDs I've tried were all 'read-only' so I can only get the b...
Hello, I am looking for any SNMP capabilities that I can set "contact_information" and "device_location" for routers and switches.I see the OID for the location with Geolocation, but that is different from what I am looking for.Examples: for the ...
Hi all, I have question about eem cron timer. I configured event manager like this.What I understood is "0 9 * * *" mean every 9 AM triggered.But actually it triggered at 00:00AMWhat am I wrong for this configuration??
Hi,Do any of you have skills in the Cisco ISR 900 Series?I am setting up a network infrastructure with a c921-4P router and two Cisco SG250 switches. All devices are new and without any configurations on them. when I wanted to create my sub-interface...
What is the replacement of the Cisco MDS 9148 ?
I am in the process of deploying a DNA Center server, DN2-HW-APL-U-V01. Reading through the appliance installation guide I see that there are two management interfaces. Network Adapter 3 is the Management Port (whose description states "Connect this...
We have a Prime Infrastructure 3.9.0 appliance that we needto transfer all the config files (network devices, config files etc.) to a new Prime Infrastructure 3.10 appliance.I haven't being able to find how to do so.
