09-02-2012 10:55 PM
Hello,
I have a question:
In Cisco Prime LMS 4.2, I get "OutOfRange" events on high temperature threshold.
For example, a device has 46.0 C while the high temperature threshold is 45.0 C
I tried to change the high temperature threshold but the only option I have is to change the "Relative Temperature Threshold".
This value indicates how close the current temperature value can be to the value that triggers an emergency shutdown, expressed as a percentage of the emergency shutdown value. For example, if the shutdown temperature is 50° C and the Relative temperature threshold is 10%, the OutofRange event occurs if the temperature exceeds 45° C.
Does anybody know if there is an option to change the high temperature threshold expressed as degrees and not as a percentage of the emergency shutdown value.
Thanks.
09-09-2012 11:52 PM
Check the following document, it will be helpful to do this:
-Thanks
12-18-2012 05:00 AM
Were you able to edit temperature values instead of percentages? I am running into the same situation.
Thanks.
12-18-2012 05:21 AM
No, you can only change percentages. As noted in the documentation:
The Environment threshold controls the monitoring of the system environment.
Indicates how close the current temperature value can be to the value that triggers an emergency shutdown, expressed as a percentage of the emergency shutdown value. For example, if the shutdown temperature is 50° C and the Relative temperature threshold is 10%, the OutofRange event occurs if the temperature exceeds 45° C.
If you want to tranlate that to an effective temperature, you will have to figure out what % of the threshold it represents.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide