07-18-2012 06:43 AM
Hi All,
I am running with LMS 3.2. I have added all the required devices to the LMS and its working fine and taking the backup of Start-up and running configuration as well as vlan information from the devices. My question is that can i configure LMS to take the Show tech-support of all the devices?
Regards.
Khalid.
Solved! Go to Solution.
07-19-2012 01:47 AM
This is possible via scheduling a job in RME for NetShow. You can have the output of any show commands including show tech support.
Network show (NetShow) commands represent a set of read-only commands. These are primarily, show commands that you can run on devices that are managed in RME.
For more details please check Using NetShow Commands section on User guide.
-Thanks
Vinod
07-19-2012 01:47 AM
This is possible via scheduling a job in RME for NetShow. You can have the output of any show commands including show tech support.
Network show (NetShow) commands represent a set of read-only commands. These are primarily, show commands that you can run on devices that are managed in RME.
For more details please check Using NetShow Commands section on User guide.
-Thanks
Vinod
07-23-2012 02:36 AM
Hi Vinod,
Thanks for your support its working fine now.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide