CISCOWORKS AND THE 3650-24

[coladmin]

I have a problem with the CISCO 3560-24 switch in Ciscoworks.

I can only see an question mark on the icon in Topology services.

I have 3560-48 switches and can see them fine.

snmp is configured the same on both switches

Is it possible that the 24 is not supported ?

Thanks

Gary

[nhabib]

Check out the previous discussion and see if it applies to your case:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1dda86dc