12-10-2010 04:57 AM
how can i move(copy) a device from common services to rme?
12-10-2010 05:08 AM
go to RME > Admin > Device managment > Device managment settings.
there you can enable the Auto allocate (this will move the CS devices automatically to the RME)
12-10-2010 05:21 AM
hi fadi twal,
firstly thanks..but i want to copy 1 device from cs to rme.is it possible?
12-10-2010 05:54 AM
you can select the option to auto allocate a certain group which this device is listed under.
if this group contain more than the device you need then you can go to
RME > Device > Device managment > Normal devices > select and suspend the un-needed devices.
in this case you will have your device in RME and the others are suspended.
hope this helps
12-10-2010 06:24 AM
ok it works thanks for your helps..
12-14-2010 11:54 PM
hi fadi twal,
i added a new device on common services.And i have clicked Enable Auto Mode (RME > Admin > Device Mgmt > Device Man. Settings)
but i can't see the new device in RME. i am searching the device in RME > Devices > Device Management | RME Devices)
shouldn't i see the new device in RME automatically?
12-15-2010 12:06 AM
yes you should,
but did you enable the Auto allocate for all devices?
12-15-2010 12:10 AM
12-15-2010 12:25 AM
yes this is correct,
so did you check if the device under one of the following:
RME > Device > device managment
12-15-2010 12:32 AM
nope, there is not no one of them..
12-15-2010 12:41 AM
can you try the following,
disable the Auto allocate (click apply) then enable it again (click apply)
then delete the device from the CS then add it again.
check the RME and let me know how it goes.
12-15-2010 11:17 PM
i did it but unfortunalety not working...
12-16-2010 02:38 AM
now i see the devices under rme devices..but i took about 2 days
can i configure the rme update time ?is it configurable or does rme update itself as soon as add device to common service?
12-16-2010 02:44 AM
rme update itself as soon as add device to common service
so it seems that there was a process stuck or the properties file not updated,
to make sure that the issue is gone try to delete the device from CS and check in RME,
then try to add it again and check RME (make sure that the device is added to the DCR correctly)
12-16-2010 02:51 AM
ok thanks a lot for your helps..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: