CiscoWorks with Edges

[Ibrahim Jamil]

Hi Folks

I M Going to Run cisco works 3.2 in my Enterprise so what is the required config in the router and switch and asa along with a basic config in the CiscoWorks it self?

[Fadi Twal]

what you need is:

-make sure that the device is reachable from the LMS server

-enable the SNMP protocol on the devices (snmp-server community RO) and if you like also to configure the RW community.

-if you need to send the syslogs to the LMS server you can use the logging host

hope this helps.

[Ibrahim Jamil]

Hi

what is needed from the lms side as basic config after setuo to see all ur activew compononts?