Clearing a NAT using EEM

[d.poppleton]

I have this configuration:

event manager applet clear_nat_1
event track 1 state any maxrun 40
action 1.0 wait 35
action 2.0 cli command "enable"
action 3.0 cli command "clear ip nat trans *"
action 4.0 syslog msg "WAN Failover, cleared NAT"

I have the maxrun and wait because we have this:

track 1 ip sla 1 reachability
delay down 30 up 30

The problem is that it isn't actually clearing the NAT. What am I missing?

[Wizard4777]

Use this commands and it should work

***************

track 1 ip sla 1 reachability
delay down 30 up 30

ip sla 1
icmp-echo 8.8.8.8 source-interface <interface?
frequency 6
ip sla schedule 1 life forever start-time now

event manager applet clear_nat_up
event track 1 state up maxrun 40
action 1.0 wait 35
action 2.0 cli command "enable"
action 3.0 cli command "clear ip nat trans for"
action 4.0 syslog msg "WAN Failover, cleared NAT"

event manager applet clear_nat_down
event track 1 state down maxrun 40
action 1.0 wait 35
action 2.0 cli command "enable"
action 3.0 cli command "clear ip nat trans for"
action 4.0 syslog msg "WAN Failover, cleared NAT"

**************