Configure 2811 via snmp

[Jackdawe67]

Is is possible to configure a 2811 router with

HWIC9ESW module via snmp?

I have snmp enabled and set-up on FE0/0.

Thanks in advance

GD

[yjdabear]

You could place a full running config for the 2811 on a TFTP server, then use SNMP to copy it to the 2811 as described in the link:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a008009463e.shtml

[Jackdawe67]

Thanks yjdabear for the reply.

I read that one and the copy config article at:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_configuration_example09186a0080094aa6.shtml

What I was after was actually being able to set a port to up and down on a switch or turn on power on a POE switch using snmp set PDUs .

Is this possible?

Thanks

GD

[yjdabear]

Gary,

That sounds at least partly doable. For interface up, you could snmpset ifAdminStatus.[ifIndex number of the interface] (1.3.6.1.2.1.2.2.1.7.ifIndex) to 1 (up). As for PoE on the 2800's HWIC, it comes down to if Cisco has included support for pethPsePortAdminEnable or an equivalent OID.

[Jackdawe67]

Thanks very much, that was helpful.

I will now have to start trawling the mibs for other interesting things to set-up

GD

[Joe Clarke]

No, the POWER-ETHERNET-MIB is not supported in the 2800 series.  The SNMP/TFTP idea is a workaround for this.