06-21-2022 05:01 AM
Hello...
So I have started to covert my Network from SNMP v2 to SNMP v3
Here is what i have on my Cisco Router but I have a strong feeling that I am missing some things and could use some help...
snmp-server group MYGROUP v3 auth access MYACL
snmp-server user MYUSERNAME MYGROUP v3 auth sha xxxxx priv aes 256 xxxxxx access MYACL
snmp-server host XXX.XXX.XXX.XXX v3 auth (I GET AN ERROR WHEN I ADD MY USER HERE)
snmp-server community xxxxxx RW MYACL
Also I think I am missing a View, Inform or Trap here...not sure which to select
I am NEW to the SNMP v3 so any help is VERY welcome
Thanks
Solved! Go to Solution.
06-21-2022 05:08 AM - edited 06-21-2022 05:11 AM
what is the router model and what version of code running ?
show version will help us to suggest better (some time due to code some config may not accept)
as per the command syntax :
#snmp-server host 1.1.1.1 version 3 auth ? ( try version 3 instead of v3)
WORD SNMPv1/v2c community string or SNMPv3 user name
06-21-2022 05:08 AM - edited 06-21-2022 05:11 AM
what is the router model and what version of code running ?
show version will help us to suggest better (some time due to code some config may not accept)
as per the command syntax :
#snmp-server host 1.1.1.1 version 3 auth ? ( try version 3 instead of v3)
WORD SNMPv1/v2c community string or SNMPv3 user name
06-21-2022 05:15 AM
Thanks for the view....here is the information:
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 15.1(4)M12a, RELEASE SOFTWARE (fc1)
Cisco 2851 (revision 1.0) with 1034240K/14336K bytes of memory.
Processor board ID XXXXXXX
2 Gigabit Ethernet interfaces
1 ATM interface
1 Terminal line
1 Virtual Private Network (VPN) Module
1 Cisco IPS Sensor(s), IPS Monitoring on slot 1
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
250880K bytes of ATA CompactFlash (Read/Write)
06-21-2022 05:24 AM
THANKS!!!!!!!!!!!!!!
That worked....I know its an OLD router but it has been EXTREMELY DEPENDABLE..............and for my home NETWORK....cant beat it..
Any other suggestions about my config or what i may bee missing???
06-21-2022 05:33 AM
Is that command that suggest works, that is the right syntax to use.
Any other suggestions about my config or what i may bee missing???
what config ? SNMP config - SNMPv3 is more secure, and you also have ACL which can only allow respected user or IP to communicate (based on config)
Hope that works for you , if that make answer, mark as resolved - it will be help for other community users.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: