Create compliance to find IP helper and replace

[tverhoeven]

I need to add ip helper addresses to over 100 routers.  Unfortunately these could be on any combinations of sub interfaces.  GI 0/0 , 0/1, 0/0/0 and so on.

Can I find helper address and the add the new one to the correct interface?

[omz]

Hi

are you looking do this manually or scripting?

so .. there are 100 routers with ip-helper already configured?

and you need to replace or add the new helper-address?

you need to first find the interface with helper-address and replace/add on that interface?

interface can be any GI 0/0 , 0/1, 0/0/0 , SVI .. ?

[tverhoeven]

Yes...The SVI are different on all routers.
I was hoping to do this through compliance but I will hand bomb if necessary