07-03-2015 01:21 PM
Hi,
I have a question about CW LMS discovery job, yesterday I set a job on system to go and fine my devices, but unfortunately it stuck in the system and does not allow me to set any other job, it is about 2 days that this job is there and never like to go out of the system. I start stop the manager deamon and even restart the server for 2 times but nothing changed.
Any one knows how can I remove this job from the server. Please do not advise me to go to the Device Discovery and cancel it, because cancel option even is off!
Regards,
Michael
Solved! Go to Solution.
07-03-2015 04:51 PM
Hi Michael,
check the status of "CSDiscovery" process in "pdshow -brief"
try to restart only this process::
pdterm CSDiscovery
and then
pdexec CSDiscovery
now , see if you the job is cleared..
if not share the pdshow -brief output , along with csdiscovery.log and ngdiscovery.log after enabling debugging.
Thanks-
Afroz
****Ratings Encourages Contributors ****
07-03-2015 04:51 PM
Hi Michael,
check the status of "CSDiscovery" process in "pdshow -brief"
try to restart only this process::
pdterm CSDiscovery
and then
pdexec CSDiscovery
now , see if you the job is cleared..
if not share the pdshow -brief output , along with csdiscovery.log and ngdiscovery.log after enabling debugging.
Thanks-
Afroz
****Ratings Encourages Contributors ****
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide