09-27-2005 01:27 AM
When we are adding a device in Ciscoworks LMS 2.5 that are running Tacacs we are experiencing problems with device credentials. When we are running a "Credential verification Report" we get "incorrect" in the "telnet" field and in the "enable by telnet" field we get "did not try"
Any suggestions on why this happends?
09-27-2005 03:54 AM
Hi Martin,
please setup in "Common Services" -> "Device and Credentials" -> "Device Management" the access credentials for the devices.
Tick the group of devices or browse to the single device and then press the button "Edit".
A new windows appears. Follow the instructions and insert the matching passwords.
Your failure happens if no credential is setup. After the credential setup open the RME and run the report again.
Cheers
Frank
09-27-2005 05:28 AM
Beware of TACACS it responds with PASSCODE, not PASSWORD. Passcode is not a valid response according to the doc I read.
09-27-2005 05:53 AM
The PASSCODE issue is resolved in RME 4.0.1 (see bug id CSCsa88849)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide