DFM 3.0.2 - Devices stuck in learning state

[david.fernandes]

Hi there again,

Started off on a fresh install of LMS 3.0.1 on Windows 2003 Enterprise box. I'm running into an issue where devices within DFM 3.0.2 are not getting past the learning state (stuck at 10%). Also, if I try to delete the devices, then they stay in the pending state unless I try rediscovering them.

Anyone else has experienced this type of issue?

[Martin Ermel · Accepted solution]

look at the following thread how to trobleshoot this issue:

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddead5c

http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Network%20Infrastructure&topic=Network%20Management&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.1ddd1ffc

[david.fernandes]

Thanks for the threads. Based on them, I believe I have resolved the problem. Specifically I needed to append the DNS suffix to the hostname under:

My Computer > Properties > Computer Name > Change > More

[yankeepwr]

Does same in Solaris 3.1.