DFM 3.1.0 all devices get stucked on 10% discover

[rgomes]

                   The DFM 3.1.3 was not oppening the Alerts and Activities, then I had removed it and reinstalled DFM 3.1.0.

After the reinstallation I got error pointing to the AAD.log. The Alerts and Activities now open empty, thats OK,  but when I tried to discover the devices on DFM, all got stucked on 10 %.

Any help is appreciated

[Michel Hegeraat]

10% means SNMP contact failed.

Fix the SNMP credentials and if these are good, probably an ACL is blocking access.

Cheers,

Michel

[rgomes]

Hi Michel

After I had removed all devices from DFM and discovered them again, they were discovered.

The only problem left was that the All alarms view does not shown any alarm.

As a workaround I created one user defined View that shows all alarms.

For this view I choosed all system device groups.

I gess there is some problem on the OGSserver that handles the groups.

Thanks for your help

[Vinod Arya]

DFM 3. sounds too old. You should atleast move to LMS 3.2 or LMS 3.2.1. LMS 3.1 has many known issues.