01-28-2010 12:39 PM
Running DFM 3.2.0 under LMS 3.2 for Windows 2003 Server Enterprise.
DFM has been pretty good about detecting power supply failures but recently I came across one power supply failure it didn't detect. This was on a 4506 running cat4500-ipbasek9-mz.122-53.SG.bin. Could there be a bug in detection of power supply failures with this firmware version?
Also, polling for power supply failures a configurable option in DFM?
Thanks,
David
01-30-2010 10:04 AM
Post an SNMP Walk of the ciscoEnvMonSupplyStatusTable for this switch.
02-01-2010 06:20 AM
SNMPv2-SMI::enterprises.9.9.13.1.5.1.2.1 = STRING: "Power Supply 1"
SNMPv2-SMI::enterprises.9.9.13.1.5.1.2.2 = STRING: "Power Supply 2"
SNMPv2-SMI::enterprises.9.9.13.1.5.1.3.1 = INTEGER: 1
SNMPv2-SMI::enterprises.9.9.13.1.5.1.3.2 = INTEGER: 6
SNMPv2-SMI::enterprises.9.9.13.1.5.1.4.1 = INTEGER: 2
SNMPv2-SMI::enterprises.9.9.13.1.5.1.4.2 = INTEGER: 2
02-01-2010 07:32 AM
It does appear DFM should have detected this. Power Supply 2 is clearly not functioning. Does the DFM Detailed Device View show PS2 as being found and managed?
02-01-2010 12:34 PM
Yes, the device is known in DFM (I did a re-import just in case)
Device Status = Known
Device Type = Switches and Hubs
Aliases = N/A
Containments = N/A
DFM Processing = Active
Time Last Discovered = 01-Feb-2010 12:28:43
Import Time Stamp = 01-Feb-2010 12:19:56
*** Data Collector Status Information ***
Error Code = N/A
Error Message = N/A
The power supply condition isn't reflected in the alerts.
Could it be that if the power supply is off to begin with when it does it's discovery, it doesn't register an alarm?
02-01-2010 02:01 PM
What does the Detailed Device View show for this switch? DFM may be ignoring it since its state is not functioning, and not "critical."
07-26-2010 03:03 AM
07-26-2010 09:51 AM
Start a new thread for your issue.
07-27-2010 05:29 AM
Hello, you can see my answer about this problem, i have a case open, the cisco TAC think the avaibility of the patch is September.
Regards
Nicolas
09-15-2010 04:52 AM
Hello
We have the same problem, no trap is coming into the LMS when we turn off a power supply of a 4500. What's the status on that? any solution?
Thank you
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide