cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
221
Views
1
Helpful
2
Replies

DHCP - Default Gateway not populating on PCs

trenaschulze
Level 1
Level 1

In the LAN 1 - I have 1 DHCP server, 3 PCs, 2 switches, and 2 routers. One of the routers interface is the gateway. I already assigned the gateway port on the router. I assigned the DHCP server an IP address, and then did the server pool to automatically assign the 3 PCs. When I turn on DHCP on the PCs, everything populates except the gateway IP address. If I assign it static, it will ping, and connect. Does anyone know why it won't assign the gateway? I added the gateway address in my pool. Thanks for your help. 

2 Accepted Solutions

Accepted Solutions

Gopinath_Pigili
Spotlight
Spotlight

Hello trenaschulze,

In DHCP server(192.168.100.3) settings, LAN1 pool is overlapping with ServerPool(default)

Remove the LAN1 Pool and Edit the Server Pool with required settings and save it works..!!

Gopinath_Pigili_2-1730788995461.png

or keep LAN1 pool, and clear (delete) server pool settings (default gateway and dns info) and save then also it works..!

 

Best regards
******* If This Helps, Please Rate *******

View solution in original post

trenaschulze
Level 1
Level 1

Thank you! That worked!

View solution in original post

2 Replies 2

Gopinath_Pigili
Spotlight
Spotlight

Hello trenaschulze,

In DHCP server(192.168.100.3) settings, LAN1 pool is overlapping with ServerPool(default)

Remove the LAN1 Pool and Edit the Server Pool with required settings and save it works..!!

Gopinath_Pigili_2-1730788995461.png

or keep LAN1 pool, and clear (delete) server pool settings (default gateway and dns info) and save then also it works..!

 

Best regards
******* If This Helps, Please Rate *******

trenaschulze
Level 1
Level 1

Thank you! That worked!

Review Cisco Networking for a $25 gift card