Disable Alarm/Event on CPI 2.0

[johnsonyu]

Hi,

We have CPI 2.0 in production. and overwhelmed interface down/up alrms from access switches are annoying. Is there a way to turn it off, I believe it is on by default.

Thanks

[AFROJ AHMAD]

Hi Tao,

I don't think , we can completely turned off the Alarms. if there is any device or a list of interfaces  for which you are concerned , then I  would suggest to change that interfcae status to ADMIN down  in PI to avoid getting alerts.

check if that help you

"Under Lifecycle Theme, go to Device Work Center Select the device.
Under the Configuration tab, select Interfaces.
Select the interface and click on Disable.
This allows you to select the interface and click on disable which
also puts the interface in the Administratively Down state "

Thanks-
Afroz
[Do rate the useful post]
****Ratings Encourages Contributors ****