We have a New config going to all routers in the field. We upload the config to flash and then allow the customer to login to router and copy from flash to startup and reload when they are ready to do the conversion. We created an eem script that will reload the router to the older version of the config if they do not login within 20 minutes and remove the eem script. They now want to bypass the manual disabling of the eem script and want it automated. I have most of it working except the write mem process.
Customer logs in and manually removes this: Works
event manager applet SetConfig
event timer watchdog time 1200
action 1.0 cli command "enable"
action 1.1 cli command "conf t"
action 1.2 cli command "file prompt quiet"
action 1.3 cli command "end"
action 2.0 cli command "copy original.cfg startup-config"
action 3.0 syslog msg "EEM forced reload"
action 4.0 reload
end
Automated removal of eem script and all its settings: Works
event manager applet Delete_SetConfig
event track 333 state up
event timer watchdog time 600
action 1.0 cli command "enable"
action 1.1 cli command "conf t"
action 1.2 cli command "no event manager applet SetConfig"
action 1.3 cli command "no ip sla 6"
action 1.4 cli command "no ip sla 7"
action 1.5 cli command "no track 111 rtr 6 reachability"
action 1.6 cli command "no track 222 rtr 7 reachability"
action 1.7 cli command "no track 333 list threshold weight"
action 1.8 cli command "no event manager applet Delete_SetConfig"
action 1.9 cli command "end"
Once the eem script above processes, we want to write running-config to startup-config: Fails
event manager applet Write_Memory
event cli pattern "no event manager applet Delete_SetConfig" sync yes occurs 1
action 1.0 cli command "write memory"
action 1.1 cli command "end"
!
Any Ideas on how to get this to work?
