EHWIC-4G-LTE-V MIB

[jason crockett]

Does anyone know if there is a MIB available for the EHWIC-4G-LTE-V card that would allow me to monitor the current RSSI level?

If I issue the command "show cell 0/1/0 radio" on my Cisco2911 router, I get the following info. I'd like to monitor the "Current RSSI" level in Solarwinds.

Router>show cell 0/1/0 radio

Radio power mode = ON

Current RSSI = -67 dBm

LTE Technology Preference = AUTO

LTE Technology Selected = LTE

[Josh Potter]

I've been looking at the MIBs and haven't been able this either, but I'm very interseted.

[dflick]

I got it by swapping the 18 for 29 on 15.4:

.1.3.6.1.4.1.9.9.661.1.3.4.1.1.1.29

SNMPv2-SMI::enterprises.9.9.661.1.3.4.1.1.1.29 = INTEGER: -49

[Daniel.Billingsly · Accepted solution]

The cisco-WAN-3G mib worked for me before this newest IOS of 15.2(4)M2 I'm using 15.1(4)M4 and able able to get SS from device.

Get signal Strength

.1.3.6.1.4.1.9.9.661.1.3.4.1.1.1.18

Get phone #

.1.3.6.1.4.1.9.9.661.1.3.1.1.4.18

Get SIM

.1.3.6.1.4.1.9.9.661.1.3.1.1.3.18

Get IMEI

.1.3.6.1.4.1.9.9.661.1.3.1.1.2.18

Roaming status

.1.3.6.1.4.1.9.9.661.1.1.1.6.18

1 unknown, 2 roaming, 3 home

[jason crockett]

Thank you Daniel. I will give this a shot.

[Daniel.Billingsly]

let me know if i can assist.

[Josh Potter]

No dice on 15.3.  I'll try falling back to 15.1 to see if that work.  Thanks for sharing those Daniel.

[jason crockett]

I got it working on 15.1(4)M4, as well. Next step is creating alerts based off the results of the custom poller. Thanks Daniel!

[Josh Potter]

Same, I went back to 15.1 and it was working.  For our mobile "network in a box" I'm going to create an arduino based microcontroller to does SNMP polls and then displays the RSSI on a small LCD dispaly for remote users to see.

[Andrew Froehlich]

Reverting back to 15.1 isn't possible anymore.  Cisco doesn't support the LTE cards with newer firmware on 15.1.  I had to move to 15.2 and am now unable to monitor RSSI.  Anyone find a way to get this value via SNMP on 15.2 yet?