Enabling Smart Software Licensing

[jendoubi Abdelbasset]

Hi
I tried to activate the smart account feature on my nexus 3548XL but I still have an error,
I hade an error when entering the commande : 
"license smart enable"

some help please !

Regards

[marce1000]

           - What is the error ?

 M.

[jendoubi Abdelbasset]

Hello,

the switch did not excute the command !.

Regards

[balaji.bandi]

follow below guide for nexus :

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/nx-os/licensing/guide/b_Cisco_NX-OS_Licensing_Guide/m-smart-licensing-for-cisco-nexus-3000-and-9000-series-switches.html

[jendoubi Abdelbasset]

hello

yes I followed the file you shared but the command " license smart enable " does not run on the switch

Regards

[balaji.bandi]

can you post show version from device please.

[jendoubi Abdelbasset]

hello,

i use the recommended version  For the 3k

Software
BIOS: version 5.3.1
NXOS: version 7.0(3)I7(9)
BIOS compile time: 06/04/2019
NXOS image file is: bootflash:///nxos.7.0.3.I7.9.bin
NXOS compile time: 8/27/2020 5:00:00 [08/27/2020 08:11:00]

and this is the output of the command

switch(config)# license smart enable
^
% Invalid command at '^' marker.
switch(config)# exit
switch# license smart enable
^
% Invalid command at '^' marker.
switch# conf t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# feature licence smart
^
% Invalid command at '^' marker.
switch(config)# exit
switch# feature licence smart
^
% Invalid command at '^' marker.

regards,

[balaji.bandi · Accepted solution]

as per i know 9.X onwards only smart License, you need to use traditional

Beginning with Cisco NX-OS Release 9.3(3), all Cisco Nexus 3000 and 9000 Series switches (except the Cisco Nexus 3016 and 3064 platform switches) support Smart Software Licensing.