I am having some trouble with a new Firepower 1010 that was delivered with 7.2.5 running on it. I was having a few problems with a port not passing traffic when set to auto-negotiate, but we defaulted the device as a troubleshooting step and can now no longer access the web GUI.
I've followed this https://community.cisco.com.mcas-gov.us/t5/network-management/can-t-connect-to-web-configuration-for-firepower-1010/td-p/5055589 without success.
I ran through the running-config and the only noticeable difference I can see is 'http server enable' missing - as seen from a known good device. I've searched multiple sites and cannot figure out how to enable that, or if that is truly the problem. I've attached a screenshot of the error we're seeing and the CLI output.
Thank you for the help
