cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
149
Views
1
Helpful
1
Replies

Help Configuring Bridging Between Two Interfaces on ASR920 Router

Muhammad-ly
Level 1
Level 1

Hello Cisco Community,

I am working with a Cisco ASR920 router and need to configure it to bridge two interfaces on the same device . I am relatively new to this kind of setup and would appreciate any guidance or examples of configuration steps.

My goal is to enable seamless Layer 2 communication between the two interfaces.

Here’s what I’m trying to achieve:

  • Bridge interface  Gi0/0/1  with interface  Gi0/0/16 so that they function as part of the same Layer 2 network.
  • Allow devices connected to these interfaces to communicate seamlessly as if on the same LAN.

Thank you in advance for your help!

Best regards,

Screenshot 2025-01-01 221457.png

 

1 Accepted Solution
1 Reply 1

Review Cisco Networking for a $25 gift card