How to get SFP info by SNMP

[aformisani]

Hi

I am trying to find a MIB to get information (eg. model) regarding the SFP inserted into a module card in Catalyst4503 with interface index (ifindex)

I found ENTITY-MIB which give all informations that I need but is using a phisical index.

I need to understand by SNMP if a particular model of SFP is inserted into the corresponding interface using the interface index.

Does enyone know other MIBs through which it is possible to get such information.

Thanks

Andrea

[Mahabir Prasad · Accepted solution]

Hi Andrea

For SFP you need to use physical index only for polling SNMP info.

There are no interface index for SFP modules.

Thanks

Mahavir

[aformisani]

Thanks Mahabir

so do you know if there is some other information that I can use to understand which SFP is inserted between 1000BASE-LH and 1000BASE-T using interface index.

Regards

Andrea

[cwallin]

Check this thread:
https://supportforums.cisco.com/thread/2014600

[aformisani]

Thanks Cwallin

I had already seen this post.

No problem I found a way to reach my purpose. The only thing is that it is always difficult to have corrispondences on a table between interfaces and gbic model installed due to different index numbers.

Thanks

Andrea