For more complex command sets I use ansible scripts to push commands to a defined set of hosts (sometimes based on conditions within the device itself).
For simple command sets where there are only a few mines at most, I use a network management software called NeDi. You configure NeDi with credentials for your devices and it can SSH/Telenet into them and execute the commands you want and show you output. I recently used it to change SNMP contact on over 300 cisco switches for example.
Both of these will take a little time to initially setup but will save time in the future.
Cisco DNA Center version 2.2.2.x includes the features and improvements that
New intelligence provides an easy, gradual, and complete adoption of SD-Access. Faster Cisco DNA Center set-up saves time and effort.
When using Cisco cellular modules with a SIM card an APN must be provided. The APN cannot be stored in the SIM card and is supplied by your SIM card provider. Cisco cellular software contains a database of well-known APNs based on the country and ...
Cisco 3850: IOS-XE/Firmware Upgrade
This procedure is aimed at Cisco 3850 switch ONLY.
IOS-XE Bundle Mode is not covered.
9300, 9500 (vanilla & high-performance), ISR 1k, ISR 4k and ASR is not covered.
Listen: https://smarturl.it/CCRS8E46Follow us: twitter.com/ciscochampionsIt’s been several years since the release of Cisco DNA Center, and it’s matured into a complete network management system, an automation and orchestration engine, an AI/ML analy...
The 2021 IT Blog Awards, hosted by Cisco, is now open for submissions. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco.com/c/en/us/t...