Hi!I am new in networking and I am trying to setup this networking.I have supposed that I have these devices possible:layer 2 switch, 24 port FE and 2 ports GErouter, 2 ports FE, 1 wan port(it doesnt metter, fiber or any)In the router I have these ip...
Forum Posts
Hello, I need to configure an S2S VPN between Firepower and RRAS, without success. There is always an error in pre-shared ikev2 authentication.Has anyone managed to make it work between these two products?
When trying to login to Cisco.com from Administration / Licenses and Software Updates / Software Update it fails to reach Cisco.com. I know the credentials I am using are good and I can telnet to cisco.com port 443 from the CLI of Prime. I can also ...
Hi everyone! I have a problem with a couple of switch cisco Catalyst 3750. I have cameras Hikivision connected to the switches and work very well for a few weeks, but now some of the ports set down and the cameras don’t work.When I shut/no shut the i...
Hi all,We have CISCO 3925 router in our organization.We need to block the access of certain websites such as facebook,orkut,youtube etc...Pls suggest how to do it using CLI or cisco configuration professional.Thanks in advance...
Hello,Does anybody know the OID that tells whether the interfaces on a switch are configured as switchport mode dot1q-tunnel for catalyst switches 29/35 etc.?
PI/admin# dirDirectory of disk:/4519816219 Mar 31 2021 13:59:37 PI-Upgrade-31x_32x_33x_34x_to_3.7.0.0.159.tar.gz20 Apr 01 2021 15:43:26 crash4096 Apr 01 2021 15:26:02 defaultRepo/4096 Apr 01 2021 16:37:15 ftp/16384 Nov 18 2017 12:52:18 lost+found/409...
Resolved! SX 20 Release
We recently upgraded the operating system on our SX 20 TelePresence devices. Now its asking for a release key. I went to the license portal, and I am able to retrieve the keys for the SX 80s. When I enter the information for the SX 20s, the portal ju...
I have defined VTY 0 15 timeout, my SSH session is on MGMT (out of band) interface and vty timeout is not working. How do I enable it for MGMT as well?
Hello Community, our customer is using Prime register for 2G/3G currently on their mobile network.very soon , 4G service will be added , but none of customer team is expert on prime register as it was installed many years ago and running smoothly. an...
HI Team, I am using the SNTC portal to capture the EOS information of Cisco Hardware devices In this unable to get the EOS information's of software Image to respective Hardware devices. Based on we have below queries. Kindly check and update. 1. So...
Resolved! subnetting a network
Hi all, I have a college assignment on cisco packet tracer networking and for additional marks the lecturer is asking that we can try subnetting , now i figured out how to do it, but I'm not sure if I'm following best practices,so its a college netw...
Hello, I have an SG220-50P switch upgraded to the latest firmware (1.2.0.3) and the ip helper-address is not yet available to be used. based on the release notes for this model of switches, the DHCP relay should be available. Am I missing anything?
Hi We can logon to router via SecureCRT, but not Putty. Please see the below screenshot. Any solution? Thank you
Resolved! EEM Output Apparently Times Out
I modified this script written by Joe Clarke to better see the ISE dACL status on switch ports. However, if the switch is a large chassis switch like a 9410 with many ports, the display output stops before getting through all of the interfaces. Is ...
