cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1146
Views
0
Helpful
0
Replies

How to setup vpn connection on rv160

Techme
Level 1
Level 1

Hi,

I trust you guys are well.

 

I purchased a new cisco rv160 router for my home and I am experiencing difficulties to configure a vpn connection.

 

I dont want to use PPTP but the client to site connection ipsec profile, here is the configuration for the C2S:

 

Enable Yes

Tunnel Name
Home_vpn
IPSec Profile

Default
(Auto Profile (IKEv1) is chosen.)
Configure higher lifetimes if this profile is used for Windows Clients.
Interface

WAN
IKE Authentication Method
Pre-shared Key
••••••••••••••••••••
Show Pre-shared Key
Enable
Preshared Key Strength Meter
Minimum Preshared Key Complexity
Enable
Certificate

Local Identifier

Local WAN IP
81.174.xx.xxx
Remote Identifier

IP Address
10.235.15.1
Extended Authentication
Group Name
vpn_users
Pool Range for Client LAN
Start IP
10.2.3.1
End IP
10.2.3.253

 

I am not certain what is the remote identifier, I assume that is the device that would need to respond to the vpn request so I added the default gateway of the router (this might be wrong). I also added a screenshot of the configuration.

 

OpenVPN appear that I need a valid ssl certificate from a CA as I dont have one I would avoid this using this option, however if its strictly required I might be able to generate one.

 

When I try connect I get an error that you can see in the screenshot attached.

 

Any help would be appreciated.

 

Thank you

0 Replies 0